A broken key extractor is a widespread problem that you may face if you are a homeowner. The most common cause of a broken key extractor is a person losing their key over the wall. You can easily prevent this if you keep your keyhole fully covered and locked. Another reason your key might get stuck in the extractor is that it has been put through the reverse. The reason why you will get a Locksmith in Charlotte North Carolina, if you have a door with a reverse, is that someone may be using the reverse as a way of breaking into your house.
A broken keyhole extractor can also be caused by people drilling into the lock and pulling it out. One way you can avoid having this happen is by not putting any fluid inside the lock. Fluid will cause the keyhole to get broken because the jigsaw blade will try to cut through the fluid. If you use any fluid, such as a nail polish remover, you should be aware that it could cause the lock to break.
If you have a deadbolt on your lock, you should know that the only way for the key extractor to work is if the lock is closed. If you remove the deadbolt, the jigsaw blade will be able to cut through the lock. The best way to fix this broken key extractor is to replace the deadbolt and start drilling again. This is the easiest solution to preventing broken key extractors. However, there are times when a key extractor gets stuck partially in the lock or completely missing from the lock.
One of the first things you should do if you find out that you have a broken key extractor is to replace the keyhole. In most cases, the deadbolt is the main part of the lock that gets broken, but it doesn’t always mean that you have to replace just the deadbolt. Sometimes the lock may have been damaged enough to where the keyhole won’t even fit anymore. In this case, you will need a jigsaw blade to cut through the lock and get to the keyhole.
The next thing you should do is take your new jigsaw blade and place it into the keyhole. Start with the outermost side first, and then work your way to the other sides of the lock. Always try to face the direction of the door when cutting. If the jigsaw blade slips out of the hole, then you can take it back out again. Once you’ve located the jigsaw blade, remove the old one. You can do this by either unscrewing the bolt that holds the jigsaw blade in place or flipping the screw clockwise so that the old blade will slide out.
Once you’ve replaced the deadbolt and jigsaw blade, you will have your new key extractor. Place the new one into the lock. Make sure the key-extractor is seated into the holes, and make sure it can’t be turned. If you need to, use pliers to hold the extractor in place. You will also want to use some oil on the screws and lock knobs of the lock since they will tend to get rusty over time.
With everything installed and working properly, you should test the key extractor. If it works, install the lock again, and reassemble the deadbolt and jigsaw blade. Reconnect the wires coming from the door and the deadbolt, and reassemble the extractor. Put everything back together, and you should be able to open your door with your key in a few seconds. If you have a broken key extractor, it’s best to replace it right away before it causes more damage.
Installing a key extractor isn’t difficult, but it does take a little bit of work. If you are having problems, you should consult the owner’s manual for help. Don’t try to fix something that isn’t broken so that you can avoid spending money on repairs.